The Safest Way To HODL

Setup Guide

Setting up Billfodl is easy!  Follow the steps below to store your Keys or Seed Words forever.

  • Carefully open all the packaging and lay it out on a clean work space (desk, kitchen table, etc)
  • Slide Billfodl open and lay it on the side where you can see the laser engraved logo and the slots for numbers 1-12.
  • Grab one of the tiles and twist the screw in the top right corner to unlock the top latch
  • Use the same tile to depress the spring at the bottom and unlock bottom latch while opening the unit 
  • Pick your tiles from the tile tray and slide them in to spell your Key or Words
NOTE: Ensure that each row your are using is full of tiles.  Use blank spaces as necessary to fill up the row. There should be no way to move the tiles when the latch is closed. ALWAYS fill the entire Billfodl.  During our extensive torture test, we found that Billfodls which are not full may warp in extreme (greater than 600 deg C) heat. If you have run out of blanks, use all of the A's, then B's... until the Billfodl is full.  
  • Close the latch and, using the tile again, secure the lock on the top right hand side of the unit.
  • Double check your data for accuracy
  • Double check that the latch is firmly locked
  • Flip your Billfodl over and repeat if necessary
  • Store your Billfodl someplace safe
  • Sleep easy knowing data is protected